Ruckus Wireless ZoneDirector 1100 User Manual page 20

ZoneDirector Physical Features
ZoneDirector 1100
Label
Console
Reset
Front Panel LEDs
Table 2 describes the LEDs on the front panel of ZoneDirector 1100.
Table 2. ZoneDirector 1100 LED descriptions
LED Label
Power (embedded on
the Power button)
Status
20
Description
DB-9 port for accessing the ZoneDirector command line
interface
Use the Reset button to restart ZoneDirector or to reset it to
factory default settings.
To restart ZoneDirector, press the Reset button once for less
than two seconds.
To reset ZoneDirector to factory default settings, press and
hold the Reset button for at least five (5) seconds. For more
information, refer to Alternate Factory Default Reset
WARNING: Resetting ZoneDirector to factory default settings
will erase all configuration changes that you made, except for
AP licenses and SSL certificates.
State Meaning
Solid Green ZoneDirector is receiving power.
Off ZoneDirector is NOT receiving power. If
the power cable or adapter is connected
to a power source, verify that the power
cable is connected properly to the
power jack on the rear panel of
ZoneDirector.
Solid Green Normal state.
Flashing Green ZoneDirector has not yet been
configured. Log into the web interface,
and then configure ZoneDirector using
the setup wizard.
Red ZoneDirector has shut down (but is still
connected to a power source).
Flashing Red ZoneDirector is starting up or shutting
down.
Method.
Ruckus Wireless, Inc.