Led Indicators - Eaton DS7 Manual

4 Operation

4.8 LED indicators

4.8 LED indicators
Status signal
Operation
Initialization
Off – No supply voltage
Supply voltage without enable (EN), only in frame sizes 3 and 4 and all sizes in the
case of DS7-34D...-D soft starters
Supply voltage and enable (EN), only in frame sizes 3 and 4 and all sizes in the case
of DS7-34D...-D BG4 soft starters
Ramp (t-Start or t-Stop)
TOR (continuous operation)
Current limitation
Configuration mode activated
Relays 23 and 24 configured as READY
Relays 23 and 24 configured as RUN
Phase sequence check enabled
Phase sequence check disabled
Warning
Overtemperature after operation (A1 switched off)
A1 start command without Enable (EN); only in sizes 3 and 4
SmartWire-DT operation, potentiometer may be inoperative (DS7-34D... only)
106
The RUN and Error LEDs are used to indicate the DS7 soft starter's operating
state.
The shades of gray below have the following meanings in the following table:
= Green RUN LED
= Red Error LED
DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com
View