Table of Contents
Advertisement
0 About this Manual
0.1 List of revisions
Publication date
09/16
09/13
07/12
11/11
06/11
04/11
07/10
0.2 Further manuals for this device
This manual contains special information that you will need to connect a soft
starter correctly and configure it to your requirements using the parameters.
The details apply to the indicated hardware and software versions.
The manual describes all construction sizes of the DS7 series soft starters.
Differences and special characteristics of each rating level and construction
size are listed accordingly.
The following significant amendments have been introduced since previous
issues:
Page
Subject
96
Extended functionality
44
Actuation of resistive loads
Fully revised; firmware version V46
145ff.
Chapter "SmartWire-DT"
All
Complete revision
89
Size 2 (16 - 32 A) – Isolated relay contacts
Size 3 and 4 (41 - 200 A) – Isolated relay contacts
All
Complete revision
56
Configuration options of DS7
216
Power supply dependent data (further)
19
Power values
Initial issue
Further information can be found in the following manuals:
On "Soft starter"
•
"Design of soft starters" - MN03902001Z-EN
(previous description AWB8250-1346D)
On "SmartWire-DT"
•
"SmartWire-DT The system" – MN05006002Z-EN
(previous designation AWB2723-1617en)
•
"SmartWire-DT module" – MN05006001Z-EN
(previous designation AWB2723-1613en)
•
"SmartWire-DT Gateways" – MN05013002Z-EN
(previous designation AWB2723-1612en)
•
"XIOC signal modules" – MN05002002Z-EN
(previous designation AWB2725-1452en
DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com
0 About this Manual
0.1 List of revisions
new
modified
deleted
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
5
Advertisement
Table of Contents
