Eaton DS7 Manual page 195

PNU PNU Access
Index Sub- rights
index
Profile-specific
927 0 rw
928 0 rw
944 0 ro
947 0 ro
947 1 ro
947 2 ro
947 3 ro
947 4 ro
947 5 ro
947 6 ro
947 7 ro
Designation Data type
ParameterAccess Unsigned16
ProcessDataAccess Unsigned16
Fault Message Unsigned16
Counter
NewestFaultNumber Unsigned16
Unsigned16
Unsigned16
Unsigned16
Unsigned16
Unsigned16
Unsigned16
OldestFaultNumber Unsigned16
DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com
Meaning
Parameter level
Defines the parameter level.
Changes are only possible if the
DS7-SWD soft starter is stopped
(state S1 or S2):
0: Local parameter access (control
signal terminals and
potentiometers)
1: Parameter access via network
2: Parameter access via network
(except for potentiometer
parameters), local access for
potentiometers
Process data level:
Defines the process data level.
Changes are only possible if the
DS7-SWD soft starter is stopped
(state S1 or S2):
0: Local control (control signal
terminals and potentiometer)
1: Control via network
2: not used
3: not used
4: Control via network – automatic
change to local control in the
event of a loss of communications
(PNU 928 = 0).
Switch back to network control as
soon as communication is re-
established.
5: Dual mode. EN/Start-Stop must
be applied simultaneously with
the interface commands. They will
only be valid if both are present.
Note:
In the case of firmware version
V46 and lower, the unit will switch
to local control automatically only
if the soft starter was correctly
started after being switched on.
1)
Fault counter
Fault Number
Fault numbers, listed
chronologically
8 SmartWire-DT
8.9 Programming
Value range DS
0 - 2 2
0 - 5 4 (from
version
V46)
0 - 65535
0 - 65535 0
0 - 65535 0
0 - 65535 0
0 - 65535 0
0 - 65535 0
0 - 65535 0
0 - 65535 0
0 - 65535 0
User
setting
191