Profidrive Diagnostics - Eaton DS7 Manual

8.10.2.1 Advanced SmartWire-DT diagnostics via PROFIBUS

8.10.3 PROFIdrive diagnostics

￫
For information on the subject of advanced diagnostics, consult
manual MN05013002Z-EN, "SmartWire-DT Gateways".
For basic information on diagnostics via PROFIBUS-DP masters,
consult manual MN05002002Z-EN, "XI/OC Signal Modules."
The manual also contains explanations regarding the access of
the diagnostic data of a PROFIBUS-DP slave module.
Diagnostic data that corresponds to the PROFIdrive profile can be sent at any
time regardless of the profile that has been chosen. It is provided via the
acyclic parameter channel of the relevant bus system.
The ERR and WARN bits in corresponding input bytes 4 to 11 are used to
show whether there are any diagnostic messages present (i.e., errors or
warnings).
Faults (ERR) can be acknowledged as follows:
• Profiles 1, 2 and 3: DS7 Start/Stop 1 ￫ 0
• Profiles 4 to 11: FaultAck = 1
Warnings (WARN) cannot be acknowledged, since they are simply messages
without a response (from the DS7-SWD soft starter).
￫
Available diagnostic messages (PNU 860.0 warnings and
PNU 944 to PNU 952 faults)￫ section 8.9.5, "acyclic data".
DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com
8 SmartWire-DT
8.10 SmartWire-DT diagnostics
213