Eaton DS7 Manual page 98

4 Operation
4.1 Checklist for commissioning
No. Activity
14 DS7-SWD
When the unit is connected to SmartWire-DT, the control
voltage must be switched on (SWD LED lit green) and the card
address must be set on the SmartWire-DT system
15 DS7-SWD
Control voltage U
specifications for the DS7 soft starter (see nameplate
specifications).
16 DS7-SWD
The SmartWire-DT address for the DS7-SWD soft starter will be
assigned automatically by the gateway when the configuration
button is pressed.
94
, U must match the relevant voltage
s c
DANGER

Hazardous voltage!
The safety instructions on pages I and II must be followed.
DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com
Note