Figure 43: Step 3: Fastening the fan with the strap.
NOTICE
When inserting the device fan, make sure not to damage the
fan's plug connections (pins) or connection cables.
To mount the DS7-FAN-032 device fan, place it on the bottom edge of the
housing (plug connectors at the top left) and fully insert without the use of
force. Then re-insert the previously removed blanking plate [3] (Fig. 41) from
below until the round fixing point snaps into position (CLICK, Fig. 43).
To remove the device fan, lift up the blanking plate from the top (at the fixing
point) using a flat screwdriver and slide out downwards. Then remove the
device fan.
CAUTION
Do not damage the connection cables and plug contacts when
removing the fan.
DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com
3.3 Flush mounting in control panel
3 Installation
65