Eaton DS7 Manual page 68

3 Installation
3.3 Flush mounting in control panel
3.3.1.1 DS7-FAN-032 device fan
64
DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com
The optional DS7-FAN-032 device can be fitted on the rear of the soft starter
sizes 1 and 2 (i.e. devices up to 32 A).
Figure 40: Fitting the fan (basic principle)
To do this, open the mounting space in the enclosure. Carefully break out the
blanking plate with a flat screwdriver (see Fig. 41):
▶ Break the four thin plastic webs [1].
▶ Lever out [2] blanking plate [3].
NOTICE
Do not break through or discard blanking plate!
It is reinserted for fastening after the device fan is fitted.
Figure 41: Step 1: Break out blanking plate
Figure 42: Step 2: Slide in the DS7-FAN-032 fan
1
4x
2
3