Eaton DS7 Manual page 196

8 SmartWire-DT
8.9 Programming
PNU PNU Access
Index Sub- rights
index
950 0 ro
1 ro
952 0 rw
962 0 ro
964 0 ro
972 0 rw
975
0 ro
1 ro
2 ro
3 ro
4 ro
5 ro
6 ro
7 ro
8 ro
9 ro
10 ro
976 0 rw
977 0 rw
192
Designation Data type
Fault Situations Unsigned16
Fault Messages Unsigned16
FaultSituationCounter Unsigned16
SamplingTime Time
Difference
Manufacturer Unsigned16
PowerOnReset Unsigned16
Drive Object
Identification
Manufacturer Unsigned16
Drive Unit Type Unsigned16
Version (SW) Unsigned16
Firmware date (Year) Unsigned16
Firmware date (day/ Unsigned16
month)
DO Class Unsigned16
DO sub class Unsigned16
DO-ID Unsigned16
reserved Unsigned16
reserved Unsigned16
Manufacturer Specific Unsigned16
FactorySettings Unsigned16
SaveParameters Unsigned16
DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com
Meaning
Number of faults and error
messages that can be stored in
the memory buffer
Fault counter: Number of faults
that have occurred since the last
reset
Note:
A reset takes place both when the
unit is switched on and when it is
switched off (up to and including
version V46).
In order to clear the fault counter,
the value has to be set to 0 (in
version V48 and higher).
Scan time in ms:
Time required to calculate T2, T4,
and D2.
Device identification
(DriveUnitIdentification) -
SWD Interface
Carries out a restart:
Notice:
Modified parameters will not be
saved. In order to save the
parameters, PNU 977.0 must be
set to 1.
Drive identification
Resets all parameters to their
default setting.
Stores all parameters in internal
memory.
Value range DS
8 8
1 1
0 – 65535
32
0 - (2 - 1) 100
0 - 65535 265
0; 1 0
0 - 65535 9
0 - 65535 16
0 - 65535 66
0 - 65535 221
0 - 65535 83
0 - 65535 0
0 - 65535 0
0 - 65535 0
0 - 65535 0
0 - 65535 0
0 - 65535 0
0; 1 0
0; 1 0
User
setting