Signals In Ds7-34D - Eaton DS7 Manual

4 Operation
4.8 LED indicators
4.8.2 Signals in DS7-34D...-D
110
In conjunction with SmartWire-DT, the RUN and Error LEDs are used to
output the following signals in devices belonging to series DS7-34D...-D
(in addition to ￫ section 4.8.1, "Operating state signals"):
Table 19: LED signals in DS7-34D...-D
RUN (green)
No control voltage via
SmartWire-DT
connection
Control voltage U via
s
SmartWire-DT
connection, without
enable or start
command (both LEDs
flashing at the same
time)
Control via
SmartWire-DT
connection (operating
signal for t-Start, TOR,
t-Stop)
￫
The states indicated by the SmartWire-DT diagnostic LED are
described in ￫ chapter 8, "SmartWire-DT".
DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com
LED status indication
Error (red)
Relay contact
TOR TOR
13/-A2 13/14
(size 1) (size 2, size
3, size 4)
RUN
23/24
(size 2, size 3,
size 4)