Eaton DS7 Manual page 193

PNU PNU Access
Index Sub- rights
index
823 0 ro
823 1 rw
840
840 0 ro
840 4230 rw
840 4240 rw
840 4250 rw
840 5110 rw
840 5410 rw
840 5460 rw
840 6310 rw
840 7500 rw
840 9000 rw
Designation Data type
Overload N2
OverloadLimit N2
FaultReaction
Fire Mode Unsigned16
HeatsinkOverUnderTe Unsigned16
mp
ElectronicsOverTemp Unsigned16
ThyristorOverTemp Unsigned16
SupplyVoltageFault Unsigned16
ThyristorFault Unsigned16
BypassDefective Unsigned16
PhaseLoss Unsigned16
CommunicationFault Unsigned16
ExternalFault Unsigned16
DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com
Meaning
Current overload as a percentage:
If the current current is lower/
higher than the DS7-SWD's rated
operational current, the value will
fall/increase.
If 100 %: PNU 723.0 = 1
Overload limit as a percentage:
If the value for PNU 823.0 exceeds
the limit value set with this
parameter, PNU 723.1 will be set
to 1.
Fault reaction:
The response to specific faults can
be set in each subindex:
0: No fault response ￫ Continue
operation
1: Set WARN bit ￫ Continue
operation and generate a warning
2: Set DIAG and ERR bits ￫ Stop
with ramp
3: Set DIAG and ERR bits ￫
Quick stop
4: Set DIAG and ERR bits ￫
Coast stop
Fire Mode
Over/under temperature heat sink
Overtemperature Electronic
Overtemperature, thyristor (I²t)
Supply voltage error
Thyristor error
(Internal) bypass defective
Phase loss
A phase loss can only be detected
while the ramp is active in the
controlled phases. Once the unit
stops or TOR is reached, the DS7-
SWD soft starter will not be able
to detect phase failures. When
TOR is reached, the soft starter
will continue running.
Additional responses will depend
on the motor protection
equipment being used.
erroneous communication
External fault
8 SmartWire-DT
8.9 Programming
Value range DS
0.00 - 200.00 % 0 %
0 - 32768 0
0.00 - 100.00 % 100 %
0 - 16384 16384
0 0
0 - 4 4
0 - 4 0
0 - 4 4
0 - 4 4
0 - 4 4
0 - 4 4
0 - 4 4
0 - 4 4
0 - 4 4
User
setting
189