Eaton DS7 Manual page 178

8 SmartWire-DT
8.9 Programming
8.9.3.6 Profiles 4, 5, 6: Outputs (control)
174
Output bytes 0 and 1 (Short) are mapped as follows on SmartWire-DT.
Table 33: Profiles 4 to 6: Output bytes 0 and 1
Byte Bit Designation
0 0 –
1 - 7
1 0 EN_Set
(Control
DS7)
1 –
2 EN_Op
3 FaultAck
4 - 7 –
DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com
Meaning
Not used
See: Profiles 1, 2, 3: Output byte 0 ￫ section 8.9.3.4,
"Profiles 1, 2, 3: Outputs (control)"
Enable Setpoint, DS7 Start/Stop:
EN_Set enables the setpoint value and starts or stops
the motor with the ramp function.
0: (deactivate setpoint value)
1: (activate setpoint value)
Not used
Operation released:
0: Stop (immediate disconnection of the output)
1: Operation
Fault Acknowledge
0: Do not acknowledge current fault
1: Acknowledge current fault (rising edge: 0 → 1)
Not used