Led Displays; Led Indicators "Ready For Operation" "Test Mode" And "Failure; Control Module (Led Displays); Ready For Operation - Eaton CEAG CG-Controller Operating Instructions Manual

11 LED displays

11 LED displays
11.1 LED indicators

"Ready for operation"

"Test mode" and "Failure"

11 .1 .1 Control module (LED displays)

11 . 1 . 1 . 1 Ready for operation
The front plate of the CG-Controller shows the
"Ready for operation" state with a green LED.
• LED green on = The entire „Emergency
lighting" system is ready for
operation.
11 . 1 . 1 .2

Test mode

The front plate of the CG-Controller shows the
"Test mode" state with a yellow LED.
• LED yellow on = One or more emergency
lighting systems arein test
mode.
11 . 1 . 1 .3

Failure

The "Failure" status is indicated by a red LED.
• LED red on = One or more emergency
lighting systems are reporting
a failure.
Table 5: LED indicators
No:
One or more
emergency lighting systems
1
Manual reset
2 Functiontest
3
Durationtest
4
Deep discharge protection
5
Block
6
Operation
7
Mains failure of UV S3/S4
8
Mains failure of UV RS485
9
Mains failure of device
10 RS485 transmission fault
11
Battery failure
12
Converter failure
13
Charge-/isol. failure
14
Luminaire failure
15 Not enough capacity
16
Battery operation
17
CG-S bus communication failure
34
Manual CEAG CG-Controller for CG 2000/ZB-S 30080001458 (C) July 2016 www.ceag.de
12 Secure-Digital-Memory
Card SD

12.1 Device configurations

12 .1 .1 Configuring devices
with SD
You can use the «Setup device» / «Dev. config.
← SD» menu item to configure devices.
This configuration can then be transferred to the
devices with the Secure-Digital-Memory Card
SD (see Figure 2).
12 .1 .2 Reading the device config-
uration and saving to SD
You can use the «Setup device» / «Dev.
config. → SD» menu item to save the device
configuration to the Secure-Digital-Memory
Card (see Figure 3).

12.2 Logbook

Logbook entries are retrieved by the system on
a regular basis. Entries that are read are saved
on the SD of the CG controller.
If no SD is plugged in, the logbook is located in
EPROM.
Ready for operation
LED green on
X
X
X
X
X
X
Test mode Failure
LED yellow on LED red on
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X