Connecting The Rs-232 Data Interface; Connecting The Cue Tone/Cue Trigger Interface - Cisco D9858 Installation And Configuration Manual

Chapter 3 Installation
Note: A Normally closed state implies the state when power is applied to the relay
in a normal operating state, without a trigger or alarm condition present.

Connecting the RS-232 Data Interface

The DCE DB-9 female connector is intended for low-speed data: 7 bits, even parity, 1
stop bit, up to 38.4 kbps (default). These outputs are user-configurable via the Setup
Menu on the front panel.
The interconnect cable from the D9858 transcoder to a PC should be straight through
(for example, no handshaking), shielded and equipped with a DB -9 male connector
at one end to mate with the rear panel RS-232 Data interface, and a female DB-9
connector to connect to the PC.
RS-232 Data Connector Pin Allocation
The table shows the RS-232 Data connector and the pin allocation:
Connector
9

Connecting the Cue Tone/Cue Trigger Interface

The D9858 transcoder is equipped with a connector labeled Cue Tone/Relay for
alarm relay outputs for remote alarm signaling. This connector provides Cue Tone,
Cue Trigger and Alarm relay functionality. These outputs are user-configurable via
the Setup Menu on the front panel.
The connector is a 15-pin sub-D female connector. The following diagram shows the
connector and the pin allocation table for Cue Tone, Cue Trigger and Alarm relay
connections.
28
Normally
closed pin
1
1
2
3
4
5
6
7
8
9
Common pin
Not connected
TxD
RxD
Not connected
Ground
Not connected
Not connected
Not connected
Not connected