Audio Device Sdi Preference Setting Command - Cisco D9800 Reference Manual

Decode Configuration Commands

Audio Device SDI Preference Setting Command

The audio decode configuration command is only supported in Version 2.26 and later.
Note
Table 179: Command Details
Command Detail
Command URL
Command Information
HTTP Methods
Access Type
Access Level
GET Syntax
POST Syntax
Setting Parameters using
command line arguments is
limited to maximum of 26
arguments after the ?.
URI Parameters (extension to the Command URL separated by /): N/A
[1]:
Note
Table 180: URI Query/Set Arguments (possible fields and values preceded by ? and separated by &)
URI Argument
device (key)
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
218
Description
https://192.168.0.1/ws/v2/service_cfg/decode/audio (for SDI Audio
Preference Setting)
Allows set or get of audio decode SDI preference setting parameter.
GET, POST
Read, Write
User, Admin
GET "https://192.168.0.1/ws/v2/service_cfg/decode/audio?
device=[device#]&sdiindex=[sdiindex#]&sdipref"
POST "https://192.168.0.1/ws/v2/service_cfg/decode/audio?
device=[device#]&sdiindex=[sdiindex#]&sdipref=[sdiprefvalue]..."
All of the URI Arguments below apply to both GET and POST. For GET, the URI arguments do not
need any values, except the device and sdiindex which must be specified. For POST the device and
sdiindex must be specified followed by any of the below URI arguments and the associated value
the user would like to set. In-depth CURL examples can be seen below following the table.
Description
Audio Device Instance
Type: Integer
Value: 1 .. 2
API Definitions