Setting Up Input Information; Setting Up The Rf Input - Cisco D9824 Installation And Configuration Manual

Setting up Input Information

Setting up the RF Input

Note: If the unit is in a disaster recovery or NIT retune recovery mode, an error
message is displayed, informing you that any changes made to the page will
interrupt the disaster recovery or NIT retune process. The error message appears
when you load, refresh, or apply changes to the page. For more information on NIT
retune, see NIT Retune Recovery (on page 10). For more information on disaster
recovery, see Disaster Recovery (on page 7).
1 From the user interface of the D9824, choose Input > Input Setup. The Input
Setup page is displayed.
2 In the RF Input Selection area, check the Use RF Input check box to activate an
RF input. You can select RF 1 to RF 4.

Setting up Input Information

151