Strobe Test; Communication / Reporting; Call/Answer Ras; Call Forward On/Off - Bosch Solution 16i User Manual

Solution16 User Guide
i
Enter the Area number in which to test the internal
sirens in and then press [OK].
3. The internal sirens will now operate for 5 seconds
and the word Bell and the alarm ICON will be
displayed on the keypad.

ALARM
4. The siren test will stop automatically after 5
seconds.
Outputs > Output Testing >

Strobe Test

This menu allows you to test the external strobe lights
fitted to the system. The test will last for 1 minute.
1. Enter [Master PIN] + [MENU]
2. Enter [4] + [9] + [2] + [OK]. If your system has been
configured to have more than one area, the keypad
will display the A = prompt.
Enter the Area number in which to test the strobe
lights in and then press [OK].
3. The strobe will now operate for 60 seconds and the
word Strobe and the alarm ICON will be displayed
on the keypad.

ALARM
4. The strobe test will stop automatically after 30
seconds.

Communication / Reporting

Programming options in this section relate to how your
alarm syetem will communicate alarm information.
Your installer will advise you on the exact makeup and
configuration of your system.
Comms > Commands >

Call/Answer RAS

This menu allows you to initiate a modem call to the
installer's off-site computer for programming changes or
updates. Your installer may request that you enter this
command so that they can remotely service and configure
you system. You should not enter this command unless
requested to do so.
Comms > Commands >
Call Forward On/Off
This menu allows you to turn on and off the call forward
feature. When you turn on call forwarding, the control
panel will automatically activate and de-activate the call
forward on and call forward off sequence accordingly when
you turn your system On and Off (arm and disarm).
22
BELL
TStStr
MENU 4-9-2
Strobe
CaLAns
MENU 5-0-1
CfOnOf
MENU 5-0-2
For this feature to work you will need to also program the
Call Forward On and Call Forward Off Numbers as detailed
later in this section.
1. Enter [Master PIN] + [MENU]
2. Enter [5] + [0] + [2] + [OK].
If call forwarding is off, the keypad will display:
If call forwarding is on, the keypad will display.
3. To turn Call Forwarding On, press the [ON] key or
press the [OFF] key to turn call Forwarding off.
4. Press [OK] to exit
Comms > Commands >

Email System Log

Reserved for future use
Comms > Commands >

Direct Link Connect

Reserved for future use
Comms > Commands >

Set Domestic Phone Number

Domestic reporting allows the control panel to send reports
to personal telephone numbers (eg. mobile telephone
numbers). Up to three different telephone numbers can
be programmed, each having a maximum of 32 digits.
A telephone call needs to be acknowledged by the user that
answers the incoming call. If the user fails to acknowledge
the call, the control panel will make another attempt to
report until the maximum number of call attempts are
reached. To acknowledge the call, the user needs to press
the [#] key on their telephone.
1. Enter [Master PIN] + [MENU]
2. Enter [5] + [1] + [5]. If the control panel is not
configured to report via domestic format, the
keypad will display the following:
If the control panel has been configured to report
via domestic format, the keypad will display
information for telephone number 1.
IS OFF
IS ON
SndLoG
MENU 5-0-4
dirCon
MENU 5-0-5
Set-Ph
MENU 5-1-5
No Opt
Bosch Security Systems 10/07 BLCC500U FTR1.01