Communication / Reporting; Call/Answer Ras; Call Forward On/Off; Check Web Email - Bosch Solution 16plus User Manual

Solution16 User Guide
Plus
2. Use the [] and [] keys to select the area that you want to
test the strobe, then press [OK].
Alternatively, you can enter the area number, then press
[OK].
The keypad will display the following during the strobe
test.
Strobe Activated. Will
Reset On exit
Press OK or MENU
Check and verify that the strobe light is on.
3. Press [OK] to exit.
Communication / Reporting
Programming options in this section relate to how you alarm
system will communicate alarm information. Your installer will
advise you on the exact makeup and configuration of your
system.
Comms > Commands >
Call/Answer RAS
This menu allows you to initiate a modem call to the installer's
off-site computer for programming changes or updates. Your
installer may request that you enter this command so that they
can remotely service and configure you system. You should not
enter this command unless requested to do so.
Comms > Commands >
Call Forward On/Off
This menu allows you to turn on and off the call forward feature.
When you turn on call forwarding, the Solution 16
panel will automatically activate and de-activate the call forward
on and call forward off sequence accordingly when you turn
Area 1 All On and off (arm and disarm).
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [5] + [0] + [2].
If the call forward status is off, the keypad will display:

Call Forward On/Off

Call Forward is OFF,
To turn ON, Press ON.
To Go Back Press OK
If the call forward status is on, the keypad will display:
Call Forward On/Off
Call Forward is ON,
To turn OFF, Press OFF.
To Go Back Press OK
2. To toggle call forward on, press the [ON] key or press the
[OFF] key to turn call forward off.
20
3. Press [OK] to save and exit, or press [MENU] to cancel.
Comms > Commands >
Check Web Email
Reserved for future use
Comms > Commands >
Email System Log
Reserved for future use
Comms > Commands >
Voice Setup
This menu allows the master user to record their own customised
greeting and zone description message that will be played back
to users that are programmed to receive domestic telephone
calls from the alarm system.
These messages should be clear enough so that the user
receiving the telephone call from the control panel can then take
the appropriate action.
This feature requires an optional voice module to be fitted to
MENU 5-0-1
the control panel by your installer. Additional programming
information is included with the voice module.
Comms > Commands >
Set Domestic Phone Number
Domestic reporting allows the Solution 16
to send reports to personal telephone numbers (eg. mobile
telephone numbers). Up to three different telephone numbers
MENU 5-0-2
can be programmed, each having a maximum of 32 digits.
A telephone call needs to be acknowledged by the user that
control
Plus
answers the incoming call. If the user fails to acknowledge the
call, the Solution 16
report until the maximum number of call attempts are reached.
To acknowledge the call, the user needs to press the [#] key on
their telephone.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [5] + [1] + [5].
If the control panel is configured to report via domestic
format, the keypad will display the following:
If the control panel has been configured to report via
domestic format, the keypad will display information for
telephone number 1.
control panel will make another attempt to
Plus
Domestic Reports Not
Enabled. Please contact
Your Security Service
Provider
Domestic Phone Number 1
631728_
Press 0-9 OK to SAVE

Bosch Security Systems 03/10 BLCC100U
MENU 5-0-3
MENU 5-0-4
MENU 5-0-6
MENU 5-1-5
control panel
Plus