Communication / Reporting; Call/Answer Ras; Call Forward On/Off; Check Web Email - Bosch Solution 64 User Manual

Communication / Reporting

Programming options in this section relate to how you alarm
syetm will communicate alarm information. Your installer will
advise you on the exact makeup and configuration of your
system.
Comms > Commands >

Call/Answer RAS

This menu allows you to initiate a modem call to the installer's
off-site computer for programming changes or updates. Your
installer may request that you enter this command so that they
can remotely service and configure you system. You should not
enter this command unless requested to do so.
Comms > Commands >
Call Forward On/Off
This menu allows you to turn on and off the call forward feature.
When you turn on call forwarding, the Solution 64 control panel
will automatically activate and de-activate the call forward on
and call forward off sequence accordingly when you turn Area 1
All On and off (arm and disarm).
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [5] + [0] + [2].
If the call forward status is off, the keypad will display:

Call Forward On/Off

Call Forward is OFF,
To turn ON, Press ON.
To Go Back Press OK
If the call forward status is on, the keypad will display:
Call Forward On/Off
Call Forward is ON,
To turn OFF, Press OFF.
To Go Back Press OK
2. To toggle call forward on, press the [ON] key or press the
[OFF] key to turn call forward off.
3. Press [OK] to save and exit, or press [MENU] to cancel.
Comms > Commands >

Check Web Email

Reserved for future use
Comms > Commands >

Email System Log

Reserved for future use
Bosch Security Systems 09/06 BLCC110U
Comms > Commands >

Set Domestic Phone Number

Domestic reporting allows the Solution 64 control panel to send
reports to personal telephone numbers (eg. mobile telephone
numbers). Up to three different telephone numbers can be
programmed, each having a maximum of 32 digits.
A telephone call needs to be acknowledged by the user that
MENU 5-0-1
answers the incoming call. If the user fails to acknowledge the
call, the Solution 64 control panel will make another attempt to
report until the maximum number of call attempts are reached.
To acknowledge the call, the user needs to press the [#] key on
their telephone.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [5] + [1] + [5].
MENU 5-0-2
If the control panel is configured to report via domestic
format, the keypad will display the following:
If the control panel has been configured to report via
domestic format, the keypad will display information for
telephone number 1.
2. Using the numeric keys, enter all the digits of the first
telephone number.
You can change a single digit by scrolling the cursor left
[←] and right [→]. For special characters (eg. , = pause *
or # etc), use the [↑] and [↓] keys. To clear all text from the
cursor position to the right, press the [OFF] key.
3. Press [OK] to program telephone number 2.
MENU 5-0-3
4. Using the numeric keys, enter all the digits of the second
telephone number (if required).
You can change a single digit by scrolling the cursor left
[←] and right [→]. For special characters (eg. , = pause *
MENU 5-0-4
or # etc), use the [↑] and [↓] keys. To clear all text from the
cursor position to the right, press the [OFF] key.
5. Press [OK] to program telephone number 3.
Solution 64 User Guide
Domestic Reports Not
Enabled. Please contact
Your Security Service
Provider
Domestic Phone Number 1
631728_
Press 0-9 OK to SAVE

Domestic Phone Number 2
4331_
Press 0-9 OK to SAVE

MENU 5-1-5
21