The Drypro 832 Stops During Startup - Konica Minolta drypro 832 Service Manual

17.1.2 The DRYPRO 832 stops during startup

Phenomenon
The initial window
stops with the
"Welcome to DRY
PRO" display
Regular window
"Warming up" is not
displayed
The operating panel
LCD is displayed, but
the status lamp does
not light
Parts to check
•
Communication Main board fault or MEC
error between the board fault
•
main board and
Main communication Assy
MEC board
connector disconnected or
broken wire
•
Insufficient voltage Main board fault or multiple
for main board power fault
•
power supply
Exposure power supply relay
Assy 1 connector disconnected
or broken wire
•
Compact flash (CF) Compact flash (CF) fault
•
malfunction
Compact flash (CF) incorrect
insertion
•
Main board LED-2 Malfunction occurred in the
lit boot program
•
Malfunction occurred in the
Linux kernel
•
Driver failed to start
Main board LED-3 Disk mount failed
lit
Stops on the Software version mismatch, or
message "Checking application startup error due to
system" OS damage
Stops on the
message " Failed to
startup shared
memory process"
Stops on the
message " Failed to
startup programs
waiting for shared
memory"
Stops on the Error occurred on the power
message " Failed to supply driver, or application
startup power startup error occurred due to OS
management damage
process"
Stops on the Software version mismatch, or
message "An error application startup error due to
occurred during the OS damage
update process"
Stops on the Failed to access the print board
message due to driver or hardware related
"Downloading print cause
software"
Stops on the Failed to access the MEC board
message
"Download MEC
software"
Stops on the Software version mismatch, or
message "Checking application startup error due to
operation" OS damage
•
Defective operation Status lamp or MEC board
of the status lamp failure
•
Broken wire, short circuit, or
disconnected connector in
LCD relay Assy
Chapter 17 Troubleshooting
Cause
Check the connection of the main
communication Assy, and if there are no
problems, replace the main board, MEC
board, and main communication Assy.
Check the exposure power supply relay
Assy1 connection, and if there are no
problems, replace the main board,
multiple power, and exposure power
supply relay Assy1.
Check that the compact flash (CF) is
inserted correctly, and if it is inserted
correctly, replace the compact flash (CF).
If this does not resolve the problem,
replace the main board.
Replace the main board.
Replace the compact flash (CF).
•
Check the Error.log of the date the
error occurred.
•
Update the software version.
If this does not resolve the problem,
replace the compact flash (CF).
•
Check the Error.log of the date the
error occurred.
•
Replace the print engine board or the
control box.
Check the connection of the
communication wire (RS-232C) between
the MEC and main board, or replace it. If
this does not resolve the problem, update
the software, or replace the CF. If this
does not resolve the problem, replace the
MEC board.
Update the software version. If this does
not resolve the problem, replace the
compact flash (CF).
Check the connection of the LCD relay
Assy, and if there are no problems,
replace the status lamp and LCD relay
Assy. If this does not resolve the problem,
replace the MEC board.
Solution
17-3