Replacing Supply Outlet Sensor - Konica Minolta drypro 832 Service Manual

Chapter 6 Replacing Lispl-832 (Optional) Loading Parts

6.4.4 Replacing Supply Outlet Sensor

This photo sensor detects film transfer at the outlet of Lispl-832.
Be sure to turn off power and remove the power cable from the electrical outlet before removing
or installing the exterior cover or replacing loading parts.
Caution
Work outline
The number of personnel and the estimated work hours required to replace loading parts is as follows:
Number of
Personnel
1
Requirements
The procedure for replacing loading parts requires the following tools:
No.
1 Various types of screwdrivers
3 Photo sensor (for replacement)
6-18
Work Hours
10 minutes
Tools
1
Install the elevating transportation unit with
reference to
in
Unit".
Caution
2
Remove the face panel for the elevating transport
unit.
・ Three screws (M3×6)
Slide the face panel so as to unhook its tabs (4 places) from
the elevating transport unit and remove it from the unit.
3
Remove the actuator assembly.
No. Tools
2 Tray (container for screws and parts removed)
" Removal Procedure (Page 6-9)"
"6.4.1 Removing/Installing Elevating Transport
•
When removing loading parts, be sure to
replace with the tray shutter attached.
If some of the film remains on the tray, the
film may be exposed.
•
Take sufficient care when handling the
tray shutter, as it may be impossible to
insert if it becomes deformed due to
rough handling.