Adjusting Sub Scan Offset (Vertical) Writing Position - Konica Minolta drypro 832 Service Manual

Chapter 14 Setting and Adjustment

14.2.3 Adjusting Sub Scan OFFSET (Vertical) Writing Position

If the unexposed portion at the end of the film is not 2mm, adjust the Main Scan OFFSET (lateral) writing position.
1
Click the [PRODUCT SETUP] button under "SERVICE INFO.".
The "PRODUCT SETUP" window appears.
2
Enter the serial number of this product in "SERIAL NO.".
4
Click the [SAVE] button.
5
Click the [BACK] button.
The "PRODUCT SETUP" window is closed. Then you will return to the Maintenance Menu window.
6
Perform "14.2.1 Checking Image Data Writing Position (Page 14-13)"
image writing position has been properly adjusted.
If it was not adjusted properly, perform
Position (Page 14-16)"
Caution
This is the end of the process of adjusting the Sub Scan OFFSET (vertical) writing position.
14-16
3
Enter the length of the unexposed portions
measured in
Writing Position (Page 14-13)"
OFFSET" entry field after calculating using the
following formula.
Example: C = 5.0 mm
•
2.0 - 5.0 = - 3.0
Result: Enter a numeric value of VD OFFSET from which
"300" is subtracted.
"14.2.3 Adjusting Sub Scan OFFSET (Vertical) Writing
again.
"14.2.1 Checking Image Data
in the "VD
again and check that the