Main Scan Offset Adjustment - Konica Minolta drypro 832 Service Manual

14.3.2 Main Scan OFFSET Adjustment

If the Main Scan OFFSET requires adjustment, adjust it in the "PRODUCT SETUP" window of the DRYPRO 832
Utility Tool.
1
Click the [PRODUCT SETUP] button under "SERVICE INFO.".
The "PRODUCT SETUP" window appears.
2
Enter the serial number of this product in "SERIAL NO.".
3
Change the settings in the "SIZE FINE TUNING (Horizontal)" entry field.
Example
Example 1mm short
1
Example 2mm long
2
4
Click the [SAVE] button.
5
Click the [BACK] button.
The "PRODUCT SETUP" window is closed. Then you will return to the "Maintenance Menu" window.
6
Perform "14.3.1 Checking Print Size (Page 14-17)"
OFFSET has been adjusted correctly.
If it has not been adjusted correctly, perform
19)".
Caution
This is the end of the process of adjusting the Main Scan OFFSET.
Calculation method
"1" / 320 ×100 ×100 = 31.25
Round off to "31"
"2" / 320 ×100 ×100 = 62.5
Round off to "63"
"14.3.2 Main Scan OFFSET Adjustment (Page 14-
Chapter 14 Setting and Adjustment
Corresponds to
Add "31" to the value in "SIZE FINE TUNING
(Horizontal)" and enter the new value.
Subtract "63" from the value in "SIZE FINE
TUNING (Horizontal)" and enter the new value.
again, and check that the Main Scan
14-19