Replacing Status Lamp - Konica Minolta drypro 832 Service Manual

Chapter 12 Replacing Loading Parts in the Exterior of Main Unit

12.4 Replacing Status Lamp

Replace the status lamp that indicates the operating status of DRYPRO 832.
•
Be sure to turn off power and remove the power cable from the electrical outlet before
removing or installing the exterior cover or replacing loading parts.
Caution
•
To avoid damage to the board caused by electrostatic discharge, wear a wrist grounding
strap with reference to
board for work.
Work outline
The number of personnel and the estimated work hours required to replace loading parts is as follows:
Number of Personnel
1
Requirements
The procedure for replacing loading parts requires the following tools:
No.
1 Various types of screwdrivers
3 Status lamp (for replacement)
12-8
"3.4 Installing a Grounding Strap (Page 3-24)"
Work Hours
10 minutes
Tools No.
2
4
1
Remove the exterior of the operation panel with
reference to
3)" in
Operation
Caution
2
Remove the status lamp relay connector (JJ27).
Caution
3
Remove the ejection unit cover.
• Two screws (M4×8)
when accessing the
Tools
Tray (container for screws and parts removed)
Grounding strap
" Removal Procedure (Page 12-
"12.2 Removing/Installing Exterior of
Panel".
When replacing loading parts, be sure to
replace with the tray shutter attached. If
some of the film remains on the tray, the film
may be exposed.
When removing the connector, do not pull by
the wires, but hold the tab on the connector
with your fingers.
Pulling by the wires too tightly can cause a
break.