Replacing Main Board - Konica Minolta drypro 832 Service Manual

17.3.1 Replacing Main Board

Follow the procedure below to replace the main board.
Continue to use the compact flash (CF) that was used previously.
Caution
Requirements
Prepare following when replacing main board.
No.
1 Replacement main board
3 DRYPRO 832 Repair Manual
START
Exit the DRYPRO 832
Remove the old main
board
Install the compact flash
Install a new main board
Start the DRYPRO 832
END
Requirements
Refer to "3.2.1 How to Exit" in the operation manual
power source breaker OFF.
Refer to "11.3 Replacing Main Board (Page 11-7)"
DRYPRO 832 unit.
Refer to "11.4 Replacing Compact Flash (Page 11-11)"
the old main board and install it to the new main board.
Refer to "11.3 Replacing Main Board (Page 11-7)"
flash installed, to the DRYPRO 832 unit.
Refer to "3.1.1 How to Start" in the operation
normally.
Chapter 17 Troubleshooting
No. Requirements
2 DRYPRO 832 Operation Manual
to exit the DRYPRO 832 and switch the
to remove the old main board from the
to remove the compact flash installed on
to install the new main board with a compact
manual, and check whether the DRYPRO 832 starts
17-63