Replacing Opposed Roller - Konica Minolta drypro 832 Service Manual

13.3 Replacing Opposed Roller

Replace the roller that transports film for exposure and heat processing and transports film to the cooling unit.
•
Be sure to turn off power and remove the power cable from the electrical outlet before
removing or installing the exterior cover or replacing loading parts.
Caution
•
The heat process unit and the area around it are hot immediately after turning off DRYPRO
832.
The upper part of the rack is particularly hot. Touching it with bare hands may cause burns.
Therefore, use working gloves, and hold the grips on the side panels.
•
The heat process unit includes five racks from V1 to V5. You must remove or install them in
a predetermined order.
Be sure to perform work following the steps. Failure to follow these steps can cause the rack
to fall that could result in damage to the surface (through which film passes) of the guide.
Work outline
The number of personnel and the estimated work hours required to replace loading parts is as follows:
Number of Personnel
1
Requirements
The procedure for replacing loading parts requires the following tools:
No.
1 Various types of screwdrivers
3 Replacement kit (opposed roller and spring)
Placing Loading Parts
No.
1 Opposed roller
2 Spring
Chapter 13 Replacing and Cleaning Loading Parts on a Regular Basis
Work Hours
30 minutes
Tools
Name
This roller transports film for exposure and heat processing and transports
film to the cooling unit.
This spring undergoes motion of transport roller.
No. Tools
2 Tray (container for screws and parts removed)
4 Cotton work gloves
Functions and Reference Sections
13-7