Replacing The Mec Board - Konica Minolta drypro 832 Service Manual

Chapter 17 Troubleshooting

17.3.5 Replacing the MEC Board

Method for replacing MEC board is different depending on the software version of the DRYPRO 832.
•
Refer to
Note
V1.01.
•
Refer to
or later.
Replacing MEC Board (Up to V1.01)
This procedure is the replacing method when the software version of the DRYPRO 832 is up to V1.01.
Refer to
Note
later.
For information about the software version of the DRYPRO 832, refer to
25)".
Follow the procedure below to replace the MEC board.
Requirements
Prepare following when replacing MEC board.
No.
1 Replacement MEC board (V1.01 or later)
3 Backup file (DRYPRO 832)
5 DRYPRO 832 Installation Manual
START
Start the server PC
Start the DRYPRO 832
Exit the application
(CS-2 and CS-3 only)
17-106
" Replacing MEC Board (Up to V1.01) (Page 17-106)"
" Replacing MEC Board (V1.02 or Later) (Page 17-108)"
" Replacing MEC Board (V1.02 or Later) (Page 17-108)"
Requirements
Start the server PC (Printlink5-IN, CS-2, or CS-3)
Connection error message is displayed when the server PC is CS-2 or CS-3.
Click the [Yes] button, and close the dialog box.
Caution
Refer to "3.1.1 How to Start" in the operation
starts normally.
If the MEC upgrade is performed at startup, the startup time may take a few minutes
longer than normal.
Note
Refer to "7.4 Closing CS-2 or CS-3" in the installation manual
if the software version is up to
if the software version is V1.02
if the software version is V1.02 or
"15.11 System Setup (Page 15-
No. Requirements
2 Upgrading file
(V1.01 or later)
4 DRYPRO 832 Operation Manual
6 DRYPRO 832 Repair Manual
manual, and check whether the DRYPRO 832
to exit CS-2 or CS-3.