Replacing Pickup Transport Motor - Konica Minolta drypro 832 Service Manual

4.2.3 Replacing Pickup Transport Motor

Replace the motor that drives the pickup roller.
Be sure to turn off power and remove the power cable from the electrical outlet before removing
or installing the exterior cover or replacing load parts.
Caution
Work outline
The number of personnel and the estimated work hours required to replace load parts is as follows:
Number of
Personnel
1
Requirements
The procedure for replacing loading parts requires the following tools:
No.
1 Various types of screwdrivers
3 Replacing Pickup Transport Motor (for replacement)
Work Hours
5 minutes
Tools
1
2
3
4
Chapter 4 Replacing Supply Unit Loading Parts
No.
2 Tray (container for screws and parts removed)
4 Precision flat blade screwdriver
Remove the supply tray, lower front cover,
connector (JJ48), light shield unit assembly and
pickup unit assembly with reference to
Removal Procedure (Page 4-11)"
Removing/Installing Pickup Unit
When replacing loading parts, be sure to
replace with the tray shutter attached.
Caution
If some of film remains in the tray, the film
may be exposed.
Remove the E ring with a precision screwdriver.
When removing the E ring, be sure not to
exert too much force. Doing so may cause
Caution
you to stab your finger with the precision
screwdriver, or may cause the E ring to
spring out and become lost.
Remove the gear.
Disconnect the wire from the wire saddles.
• Wire saddles in three locations
Tools
"
in "4.2.2
Assembly".
4-15