Konica Minolta drypro 832 Service Manual page 31

Installation Procedure
This is the end of the process of installing the supply tray.
Chapter 3 Basic Operations
1
Pull out the rails.
2
Install the tray on the rails.
Place the supply tray so that the pinhole in the rails aligns
with the pin position on the back of the supply tray. Push in
the supply tray until it clicks into place.
•
Be careful not to push the supply tray
excessively, as it can distort the rails.
Caution
•
If the tray unit is not positioned properly, it
may interfere with the main unit and it
may become impossible to insert into the
unit.
3
Put the supply tray back into the main unit.
4
Remove the tray shutter and return it to the
previous position.
Take sufficient care when handling the tray
shutter, as it may be impossible to insert if it
Caution
becomes deformed due to rough handling.
3-3