Sub Scan Offset Adjustment - Konica Minolta drypro 832 Service Manual

Chapter 14 Setting and Adjustment

14.3.3 Sub Scan OFFSET Adjustment

If the Sub Scan OFFSET requires adjustment, adjust it in the "PRODUCT SETUP" window of the DRYPRO 832
Utility Tool.
1
Click the [PRODUCT SETUP] button under "SERVICE INFO.".
The "PRODUCT SETUP" window appears.
2
Enter the serial number of this product in "SERIAL NO.".
3
Change the settings in the "SIZE FINE TUNING (Vertical)" entry field.
Example
1mm short
1
Example
3mm long
2
4
Click the [SAVE] button.
5
Click the [BACK] button.
The "PRODUCT SETUP" window is closed. Then you will return to the Maintenance Menu window.
6
Perform "14.3.1 Checking Print Size (Page 14-17)"
OFFSET has been adjusted correctly.
If it has not been adjusted correctly, perform
20)".
Caution
This is the end of the process of adjusting the Sub Scan OFFSET.
14-20
Example Calculation method
"1" / 400 ×100 ×100 = 25
"3" / 400 ×100 ×100 = 75
Corresponds to
Add "25" from the value in "SIZE FINE
TUNING (Vertical)" and enter the new value.
Subtract "75" from the value in "SIZE FINE
TUNING (Vertical)" and enter the new value.
again, and check that the Sub Scan
"14.3.3 Sub Scan OFFSET Adjustment (Page 14-