Replacing Sub Scan Nip Motor - Konica Minolta drypro 832 Service Manual

Chapter 7 Replacing Sub Scan Unit Loading Parts

7.10 Replacing Sub Scan Nip Motor

Replace the motor that drives the nip in the sub scan unit.
Be sure to turn off power and remove the power cable from the electrical outlet before removing
or installing the exterior cover or replacing loading parts.
Caution
Work outline
The number of personnel and the estimated work hours required to replace loading parts is as follows:
Number of
Personnel
1
Requirements
The procedure for replacing loading parts requires the following tools:
No.
1 Various types of screwdrivers
3 Sub Scan nip motor (for replacement)
7-30
Work Hours
15 minutes
Tools
1
Remove the sub scan unit with reference to
"
Removing/Installing Sub Scan Unit (Including the
Exposure Unit and Position Regulation
Caution
2
Refer to
Unit (Page 8-3)"
Caution
No. Tools
2 Tray (container for screws and parts removed)
Removal Procedure (Page 7-4)"
•
When replacing loading parts, be sure to
replace with the tray shutter attached. If
some of the film remains on the tray, the
film may be exposed.
•
When pulling out the sub scan unit, be
careful not to get it hung up on a wire.
•
The sub scan unit weighs approximately
16kg.
Carefully perform work when unloading the
sub scan unit from the main unit or
transporting it to work site.
•
If you place the removed sub scan unit on a
table, it may become extremely unstable. It
should be kept in mind that applying
excessive pressure could overturn the unit.
step 2 and 3 in "8.2 Replacing Exposure
and remove the exposure unit.
The exposure unit includes optical parts.
Be careful not to subject to a strong impact.
in "7.2
Unit)".