Board Diagram; Main Board - Konica Minolta drypro 832 Service Manual

Laser imager

Hide thumbs Also See for drypro 832:

Table of Contents

Chapter 18 Technical Information

18.3 Board Diagram

Connectors other than those shown above are not used, and have not been packaged.

Always turn the power of the DRYPRO 832 OFF when plugging in or pulling out a connector

This board uses a coin type lithium battery. When disposing the batteries, always follow local

government regulations.

Also, take the following precautions concerning batteries that are removed.

Power source

MEC communication

(1) Do not recharge, disassemble, deform, heat, solder, or bring into contact with flame.

(2) When replacing or reusing, be careful not to install the batteries backwards.

(3) Store batteries out of the reach of young children, and immediately obtain medical

assistance if swallowed.

(4) Do not intentionally short or store or carry with metal products such as necklaces.

(5) When storing and disposing batteries, insulate both ends of the battery with tape or

other means in order to prevent contacting with other batteries or other metal products.

Exposure communication

Console Output

Show Quick Links

Table of Contents