Konica Minolta drypro 832 Service Manual page 461

Replacing Compact Flash (V1.02 or Later)
This procedure is the replacing method when the software version of the DRYPRO 832 is V1.02 or later.
Refer to " Replacing Compact Flash (Up to V1.01) (Page 17-64)"
Note
V1.01.
For information about the software version of the DRYPRO 832, refer to
25)".
Follow the procedure below to replace the compact flash.
•
Before replacing the compact flash, replace the main board as shown in
Main Board (Page
Caution
•
If there are IP Addresses "192.168.20.161" or "192.168.20.179" used in the same network
environment of the facility, you need to release these IP addresses before the procedure.
•
Data for "Film Count" and/or "Maintenance Schedule" may be lost if the procedure is not
carried out correctly. Loaded film needs to be discarded and newly loaded when the data is
lost, so take note of the "Film Count" and "Maintenance Schedule" before starting the
procedure.
For details, refer to
31)", and "15.9 Film Setup (Page
Requirements
Prepare following when replacing compact flash (CF).
No. Requirements
1 Replacement compact flash
(V1.02 or later)
3 Backup file (DRYPRO 832)
5 DRYPRO 832 Installation Manual
START
Exit the DRYPRO 832
Refer to
unit Power source breaker OFF.
Replacing the compact Refer to
flash
Starting the server PC If the power for the server PC is OFF, turn the power ON.
Caution
Exit the application Refer to
(Only for CS2 and CS-3)
Upgrade server PC Refer to
V1.02R00 or later.
If the installation completes normally, the server PC will automatically restart.
Caution
17-63)", and check that the DRYPRO 832 main unit starts up normally.
"15.9 Film Setup (Page 15-20)",
15-20)".
No.
2 Upgrading file
(V1.02 or later)
4 DRYPRO 832 Operation Manual
6 DRYPRO 832 Repair Manual
"3.2.1 How to Exit" in the operation manual
"11.4 Replacing Compact Flash (Page 11-11)"
Connection error message is displayed when the server PC is CS-2 or CS-3.
Click the [Yes] button, and close the dialog box.
"7.4 How to Exit CS-2 and CS-3" in the installation manual
"16.4 Upgrade Information (Page
Connection error message is displayed when the server PC is CS-2 or CS-3.
Click the [Yes] button, and close the dialog box.
Chapter 17 Troubleshooting
if the software version is up to
"15.11 System Setup (Page 15-
"17.3.1 Replacing
"15.14 Maintenance Schedule (Page 15-
Requirements
to exit the DRYPRO 832 and switch the
to replace the compact flash.
to exit CS-2 or CS-3.
16-12)", and upgrade the version of server PC to
17-73