Software Upload - Leica Builder Series User Manual

Builder, System Info and Instrument Protection
13.3
Description
Access step-by-
step

Software Upload

To load the application software or an additional language, connect the instrument
to Leica's Construction Data Manager via the serial interface or USB cable and load
using Tools - Software Upload. Refer to the Construction Data Manager help for
further information. For instruments fitted with a Communication side cover, the
software can be loaded via USB memory stick. This process is described below.
1. Turn on the instrument by pressing the
2. Make sure that THEO mode is active.
3. Press the ESC key for approximately 5 seconds.
4. Press the SW/LANG button to get to the next step.

Never disconnect the power supply during the system upload process. The
battery must be at least at 75% capacity before commencing the upload.
key.
174