Leica Builder Series User Manual page 90

Builder, Program Mode, for Builder 200 or higher
MEASURE only
step-by-step

1. Make sure that PROG Mode is active.
2. Make sure that <Measure&Record: MEASURE> is set.
Refer to "6 Configuration Mode" for information on how to make the setting.
3. Position the prism at the point to be measured.
4. Press MEASURE to measure the distance.
5. No points or results are stored and the next measurement can be started directly
by pressing MEASURE again.
Use Switch Key 2 to switch between MEASURE only and All-in-1 respectively
MEAS/REC depending on the previously chosen Measure mode (only for Builder 400
and 500).
90