Combining
MEASURE and
RECORD step-by-
step
Builder, Program Mode, for Builder 200 or higher
The key combination of MEASURE and RECORD can be used to measure non acces-
sible points with the prism, for example building corners.
1. Make sure that PROG Mode is active.
2. Make sure that <Measure&Record: MEAS/REC> is set.
Refer to "6 Configuration Mode" for information on how to make the setting.
3. Position the prism at the same distance from the instrument as the building
corner to be measured.
4. Press MEASURE to measure the distance.
5. Aim at the building corner.
6. Press RECORD to store the measured distance to the prism and the angles to
the corner of the house.
89