Table of Contents
Advertisement
Using MAUI
Position Cursors
To change cursor measurement time/level, drag cursor markers to new positions on the grid. The
cursor readout will update immediately.
To place horizontal cursors on zooms or other calculated traces where the source Horizontal Scale
has forced cursors off the grid, drag the cursor readout from below the Timebase descriptor to the
grid where you wish to place the cursors. The cursors are set at either the 5 (center) or 2.5 and 7.5
divisions of the grid. Cursors on the source traces adjust position accordingly.
Change Trigger
To change the trigger level, drag the Trigger Level indicator to a new position on the Y axis. The
Trigger descriptor box will show the new voltage Level.
To change the trigger source channel, drag-and-drop the desired channel (Cx) descriptor box onto the
Trigger descriptor box. The trigger will revert to the last trigger set on that channel.
23
Advertisement
Table of Contents
