Table of Contents
Advertisement
Front Panel
Setup opens the Trigger setup dialog. Press it again to close the dialog.
The READY indicator is lit when the trigger is armed and ready. TRIG'D is lit momentarily when a
trigger occurs.
Auto sets Auto mode, which triggers the oscilloscope after a set time, even if the trigger conditions
are not met.
Normal sets Normal mode, which triggers the oscilloscope each time a signal is present that meets
the trigger conditions.
Most front panel controls duplicate functionality also available
through the touch screen display.
All the knobs on the front panel function one way if turned and
another if pushed like a button. The first label describes the
knob's principal "turn" action, and the second label describes
its "push" action.
Front panel buttons light up to indicate which traces and
functions are active. Actions performed from the front panel
always apply to the active trace.
Top Row Controls
Auto Setup performs an
will be prompted for a confirmation. Press the button again or
use the touch screen to confirm.
Default Setup resets the oscilloscope to the factory default
configuration. After the first press, you will be prompted for a
confirmation. Press the button again or use the touch screen
to confirm.
Clear Sweeps resets the acquisition counter and any
cumulative measurements.
Touch Screen toggles on/off touch screen functionality.
Print captures the entire screen and outputs it according to
your
Hardcopy
settings.
HD turns on/off HD1024 technology.
Trigger Controls
The front panel Level knob changes the trigger threshold level
(V). The number is shown on the Trigger descriptor box.
Pushing the knob sets the trigger level to the 50% point of the
input signal.
Oscilloscope Overview
Auto
Setup. After the first press, you
7
Advertisement
Table of Contents
