Scan Views - Teledyne HDO9000 Operator's Manual

Scan Views

Scan Views are different ways to view your WaveScan results. You can choose to display views
simultaneously or visit them sequentially. Just check the boxes at the bottom of the WaveScan
dialog for those views you wish to display. Uncheck the box to turn off the view.
Note: The number of grids varies from one to three depending on which views are enabled.
WaveScan handles this function automatically, and you cannot move traces among grids as in
normal operation.
You'll find additional controls for manipulating Scan Overlay and Zoom on their respective dialogs. If
you turn on these traces from those dialogs, you must turn them off from there, too.
Source Trace
By default, the source trace is displayed in the top grid, with markers indicating points in the trace
that meet the search criteria.
Table
Table view displays a table of measurements relevant to your chosen Search Mode next to the source
trace. Times view adds columns to the table showing Start and Stop Times for each event.
Scan Overlay
Scan Overlay view plots the location of captured events in a new trace. Colored overlays provide quick
reference to sections of the waveform.
Zoom
Zoom view works exactly as it does elsewhere in the X-Stream software, creating a new trace that is
a magnified section of the source trace. A Zx tab appears by default when you launch WaveScan; see
zoom factor controls
A unique feature of the WaveScan Zoom is that you can automatically zoom the events captured from
the source trace by touching the Prev/Next buttons on the Zx dialog. You can also select a row from
the Table, and you are automatically relocated to that point on the zoom.
for an explanation of the remainder of the controls found on this dialog.
Analysis Tools
127