Using Web Editor - Teledyne HDO9000 Operator's Manual

HDO9000 High Definition Oscilloscopes Operator's Manual

Using Web Editor

Whereas with Math on Parameters you can apply a single math operation to a measurement
parameter, the Web Editor enables you to create custom processes that potentially chain many
operations and apply them to the output of a single parameter or math function. These processes are
integral to the operation of the instrument; there is no need to export data to other programs.
Processes are "programmed" in the X-Stream application simply by dragging and dropping a series of
blocks representing different math functions or measurements and connecting them to form a flow
chart—a "processing web." The parameter value shown in the Measure table represents the numeric
result of this process flow applied to the raw, acquired sample. Math functions would likewise
display the waveform trace that results from the process.
Create Processing Web
1. From the menu bar, choose Measure > Measure Setup.
2. On the Measure dialog, choose Measure Mode My Measure.
3. Open the Px dialog of an unused parameter (or one that you want to change) and select
Advanced Web Edit.
4. Touch the Show Processing Web button. You will see a "peg board" display with potential input
sources aligned along the left, and a terminal marked with the parameter number to the far
right.
On the Source Filter subdialog, deselect any types (e.g., zooms) that you do not want to use in
the process. This simplifes the display and reduces the need to scroll.
90