GRAUPNER MC-32 Manual page 98

RECEIVER CHANNEL MAP
Rx Input Ch 1 Rx Output Ch
Rx Input Ch 2 Rx Output Ch
Rx Input Ch 3 Rx Output Ch
Rx Input Ch 4 Rx Output Ch
After selection of the desired output with the selec-
tion keys of the left or right touch pad, the appropriate
value fi eld will be framed. Briefl y tap on the centre
SET key of the right touch pad. The current setting
will be displayed in inverse video. Now use the selec-
tion keys of the right touch pad to select the desired
input channel's respective transmitter output, see
page 234.
BUT CAUTION:
If you wish to operate two servos with one
control function, for example such as trans-
mitter control function 2 (roll) which is divided
up into control channels 1 & 2 for left and right roll
servos for the "3Sv(2Roll)" option in the »Heli type«
menu; then "map" the corresponding transmitter
outputs, in this case for channels 1 & 2 (= inputs to
the receiver) accordingly.
The number of lines available in the list
(outputs) corresponds to the maximum
number of servos which can be attached to
the given receiver.
• If you see the warning ...
98 Program description - Base setup models | Helicopter models
BIND1
1
2
... then there is no bound receiver within range.
3
If the case may be, switch the RF module or/and
4
your receiving system on.
With the »Tx. output swap« option, available
•
on the mc-32
transmitter's control functions can be interchanged
in any way; it is also possible to assign multiple
outputs to one and the same control function. In
the interests of clarity however we strongly advise
that you use only one of these two options.
Channel assignment on other receivers
As already mentioned, the "Rcv Ch map" menu option
can be used to freely distribute the
transmitter's 16 control channels across up to four
receivers, whereby the numbering of outputs (servo
connections) as well as the maximum number of
available lines (outputs) will correspond to the maxi-
mum number of servo connections available on the
given receiver.
RECEIVER CHANNEL MAP
Rx Input Ch
Rx Input Ch
Rx Input Ch
Rx Input Ch
After selection of the desired output with the selection
keys of the left or right touch pad, the respective input
fi eld will be framed.
C A N ' T
R E C E I V E
D ATA
O K
transmitter, see page 234, the
mc-32 HoTT
BIND2
16 Rx Output Ch 1
16 Rx Output Ch 2
16 Rx Output Ch 3
16 Rx Output Ch 4
SET
Tap the centre key of the right touch pad. The
current setting will be displayed in inverse video. Now
select the desired input channel with the selection
keys of the right touch pad. For example, suitable to
the above rudder example.
RECEIVER CHANNEL MAP
Rx Input Ch 4 Rx Output Ch
Rx Input Ch 4 Rx Output Ch
Rx Input Ch 4 Rx Output Ch
Rx Input Ch 4 Rx Output Ch
Note:
The number of lines available in the list
(outputs) corresponds to the maximum
number of servos which can be attached to
the given receiver.
RF transmit
This menu line provides an option for manually
switching the transmitter's RF transmission on and
off to specifi c models while the transmitter is in op-
eration. For example, to save power while a model is
being programmed.
If this line option was set to OFF, it will be
canceled (i. e. set to ON) the next time the
transmitter is switched on.
If necessary, use the  selection keys of the left
or right touch pad to move into the "RF transmit" line
then activate the option with a brief tap on the centre
SET button of the right touch pad.
BIND2
1
2
3
4