GRAUPNER MC-32 Manual page 188

Aileron 2  4 rudder
W I N G M I X E R S
Multi-flap menu
Brake settings
Aileron 2 4 rudder
Flaps 6 3 elevator 0%
Normal
Here, you can set the degree to which the rudder
follows commands acting on ailerons. This is used
in particular in connection with aileron differential to
suppress adverse yaw and thus make it easier to fly
"clean" curves. You can of course still issue separate
commands to the rudder.
The mixer direction is typically chosen to
ensure that the rudder moves in the direction
of the aileron that is deflected upwards.
Settings are always made symmetrically relative to
the neutral point of the aileron stick.
The adjustment range of ± 150 % lets you set the
direction of deflection as appropriate. Optionally, this
mixer can be activated and deactivated with of the
switches or a control switch that is not self-restoring
so the model can be controlled with only the ailerons
or rudder if desired.
A simultaneous tap on the  or  keys of the
right touch pad (CLEAR) will reset a changed value
in an active (inverse video) field back to 0 %.
A value of around 50 % is generally an excellent start-
ing point.
188 For your notes
Flaps 6  3 elevator
Multi-flap menu
Brake settings
0% ––– Aileron 2
0% ––– Flaps 6
When setting camber-changing flaps, one side-effect
can be to generate moments causing movement
around the transverse axis. Equally, however, it may
also be desirable that e. g. your aircraft model opts for
a more pacey flight style with the flaps slightly raised.
This mixer can be used to achieve both results.
With this mixer, the extension of the flaps – depending
on the value configured – automatically ensures the
elevator position follows suit. Symmetrical or asym-
metrical settings relative to the neutral point of the
flap control are possible.
If required, the mixer can be switched on or
off by assigning a switch in the right column.
Values can be set in the range ±150 %. The
"typical" values configured for this mixer are single-
digit or low two-digit values.
A simultaneous tap on the  or  keys of the
right touch pad (CLEAR) will reset a changed value
in a given active (inverse video) field back to 0 %.
Note:
If a transmitter control or switch has been
assigned in the »Control adjust« menu, as
described under "FL" on page 183, then
that setting will also have an effect on this mixer.
W I N G M I X E R S
4 rudder 0% –––
3 elevator 0% 0% –––
Normal