Table of Contents
Advertisement
Smoothing the Channel 1 curve
In the example below, sample reference points have
been set:
reference point 1 to 0 %,
reference point 2 to +25 % and
reference point 3 to -75 %
as described in the last section.
Channel 1
C U R V E
Input
–50%
Curve
Output
0%
off
Point
1
0%
Normal
This "jagged" curve profile can be smoothed auto-
matically simply by pressing a button.
Starting from the situation in the previous illustra-
tion, first press the
SET
button or the
right-hand four-way button to conclude the procedure.
Use the Select button of the right-hand touch pad
to move up to the Value field of the "Curve" line, then
SET
press the
button of the right-hand touch padonce
more:
Channel 1
Input
Curve
Output
on
Point
Now press one of the Select buttons of the right-hand
four-way button in order to switch from "(Curve) off" to
"(Curve) on" (or vice versa). This process with a brief
2
tap on the centre
1
ESC
key on the left touch pad
–
+
3
Channel 1
Input
Curve
Output
ESC
key of the
on
Point
Note:
The curves shown here are for demonstration
purposes only and are not at all representative
of real throttle curves. For real-world
application examples, see the programming examples
on page 333.
C U R V E
–50%
2
1
0%
1
0%
–
Normal
SET
key on the right or the centre
C U R V E
2
–50%
1
0%
1
0%
–
Normal
Program description - Channel 1 curve | Helicopter models
+
3
+
3
145
Advertisement
Table of Contents
