Table of Contents
Advertisement
SET
... and then briefly tap the centre
touch pad. Now use the touch pad's selection keys to
make your choice from the four possible time delays
(0.25 s, 0.5 s, 0.75 s and 1 s) offered.
A simultaneous tap on the or selection keys
of the right touch pad (CLEAR) will reset the inverse
video field to its default value 0.25 s.
Afterwards, select the STO field at the bottom right of
the display with the selection keys on the left or
right touch pad. Now put the servos which have been
switched into position mode into their desired posi-
tions SIMULTANEOUSLY with the respective operat-
ing elements.
Briefly tap the centre
SET
key of the right touch pad
to store these positions as the fail-safe setting for the
receiver, so that it can revert back to them if interfer-
ence is experienced.
Successful storage of the positions is confirmed
briefly on the screen:
F A I L
S A F E
Position stored
Pos
hold
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
DELAY : 0.25s
If instead there is the following message...
F A I L
S A F E
No Binding
Pos
hold
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
DELAY : 0.25s
key of the right
... is displayed, there is no connection to a receiver.
So switch on if necessary the RF module of the trans-
mitter and / or receiver system of your model.
Attention:
•
Please note that decisive fail-safe
settings are stored in the
receiver! Therefore, following a
change of receivers, these fail-safe
settings should be renewed and in the
previous receiver they should be erased,
if necessary per Reset, see page 52.
• Ensure you make use of this safety net
by at least programming the following
for a fail-safe incident: for glow-powered
models, set the motor throttle position
to idle; for electric models, set the
motor function to stop, or "Hold" for
helicopter models. If interference should
occur, the model is then less likely to
fly off on its own and cause damage
to property or even personal injury.
Consider asking an experienced pilot for
advice.
STO
STO
Programmbeschreibung - Fail-Safe
225
Advertisement
Table of Contents
