Stick Conversions - GRAUPNER MC-32 Manual

Stick conversions

Neutralization
Both the left and the right stick can be confi gured for
neutralized or non-neutralized operation. Open the
transmitter.
To change the stick's factory setting, locate the screw
shown in the fi gure below enclosed in a white circle.
Note:
The aggregate for the right stick is a mirror
image of the left stick so the corresponding
screw for the right stick is on the right side
just below the middle.
Now turn this screw down until the respective stick is
free to move from limit to limit - or turn the screw out
until the stick again completely self-restoring.
Brake spring and ratchet
The outboard screw of the two marked in the next
fi gure adjusts the braking force and the inboard screw
adjusts the strength of the ratchet for the respective
stick.
Note:
The aggregate for the right stick is a mirror
image of the left stick so corresponding
screws for the right stick are located at the
top left.
Stick restoring force
The stick's restoring force can also be adjusted to the
pilot's preference. The adjustment is located next to
the return springs, see markings in the fi gure below.
Spring force for the given direction of motion can be
adjusted by turning the respective screw with a Phil-
lips screwdriver.
• clockwise = stronger return,
• counter-clockwise = weaker return.
vertical
horizontal
Note:
The aggregate for the right stick is a mirror
image of the left stick so corresponding
screws for the right stick are located to the
right of the middle.
General operating notices 21