Table of Contents
Advertisement
Phase 1
Normal
yes
Phase 2
Launch
yes
Phase 3
Dist.
yes
Phase 4
yes
Phase 5
yes
Name
Timer
Motor
Following a brief tap on the centre
right touch pad, the switchover time value in the field
displayed in inverse video can be changed within a
range of 0 and 9.9 s.
Example:
Phase 1
Normal
yes
Phase 2
Launch
yes
Phase 3
Dist.
yes
Phase 4
yes
Phase 5
yes
Name
Timer
Motor
The switchover time from any other phase to Phase 1
«normal» will take 2.2 s.
The time for a switchover from, for example, Phase 1
to Phase 3, is set to 1.1 s and the time for a switchover
from Phase 1 or 3 to Phase 2 "Launch" is 1.5 s.
Such asymmetric transition times can be useful when,
e. g. switching between extremely different flight phas-
es, such as between aerobatics and normal flight.
A simultaneous tap on the or keys of the
right touch pad (CLEAR) will reset the time in the cur-
rently active value field back to 0.1.
Note:
The "switch time" set here applies uniformly
to all settings that are specific to flight
phases, and thus to all mixers activated in the
»Wing mixers« menu, see page 172.
156 Program description - Phase settings | Winged models
Accordingly, the transition between flight phase-
0.1s
specific mixers does not occur abruptly. However, if
individual servos are to be switched without a delay
0.1s
–
then these can be defined accordingly in the »Non-
0.1s
–
delayed chan« menu (see page 163).
0.1s
–
0.1s
–
Sw. time
SET
key of the
0.1s
0.1s
–
1.1s
–
0.1s
–
–
0.1s
Sw. time
Advertisement
Table of Contents
