Table of Contents
Advertisement
Aileron 2 4 rudder
W I N G
M I X E R S
Brake settings
Aileron
2
4
rudder
Elevator
3
6
flaps
0%
6
3
elevator
Flaps
0%
Normal
Here, you can set the degree to which the rudder
follows commands acting on ailerons. This is used
in particular in connection with aileron differential to
suppress adverse yaw and thus make it easier to fly
"clean" curves. You can of course still issue separate
commands to the rudder.
The adjustment range of ±150 % lets you set the
direction of deflection as appropriate. Optionally, this
mixer can be activated and deactivated with one of
the switches that is not self-restoring or a control
switch so the mo del can be controlled with only the
ailerons or rudder if desired.
Typically, this mixer is set so that the rudder is
deflected to the same side as the upward-
oriented aileron, and you will find that setting
a value of around 50 % is usually highly appropriate.
Settings are always made symmetrically relative to
the neutral point of the aileron stick.
A simultaneous tap on the or keys of the
right touch pad (CLEAR) will reset a changed value
in a given active (inverse video) field back to 0 %.
Elevator 3 6 flaps
Brake settings
0%
–––
Aileron
2
0%
–––
Elevator
3
6
0%
–––
Flaps
To provide support for the elevator for tight turns
and aerobatics, this mixer can be used to make the
flap function follow controls sent to the elevator. The
mixer direction chosen must ensure that the flaps are
deflected downwards when the elevator is oriented
upwards and vice versa for a downward-oriented
elevator – i. e. in opposite directions. This mixer can
be made optionally on/off switchable with one of the
switches that is not self-restoring or a control switch.
To configure symmetrical mixer values, move the
elevator stick to its centre position, so that the marker
frame surrounds both value fields. To configure asym-
metric values, move the stick to the corresponding
side.
Values in the range -150 % to +150 % are possible, so
as to adjust the function to the direction of servo rota-
tion or direction of flap deflection.
A simultaneous tap on the or keys of the
right touch pad (CLEAR) will reset a changed value
in a given active (inverse video) field back to 0 %.
The "typical" values configured for this mixer
are single-digit or low two-digit values.
W I N G
M I X E R S
4
rudder
0%
–––
6
flaps
0%
0%
–––
3
elevator
0%
0%
–––
Normal
Flaps 6 3 elevator
W I N G
M I X E R S
Brake settings
Aileron
2
4
rudder
Elevator
3
6
flaps
0%
6
3
elevator
Flaps
0%
Normal
This mixer is used to set elevator (pitch-trim) compen-
sation when a flap command is given. This typically
enables you to adjust the model's airspeed automati-
cally when flaps are lowered.
If you have used the »Control adjust«, page 118, to
assign Input 6 to a transmitter control or switch then
this also affects this mixer.
Depending on the position of the flap control, either
a symmetrical or asymmetric setting within the range
±150 % is possible.
A simultaneous tap on the or keys of the
right touch pad (CLEAR) will reset a changed value
in a given active (inverse video) field back to 0 %.
If required, the mixer can be switched on or off by as-
signing a switch in the right column.
The values configured for this mixer are
typically in the single-digit range.
Program description - Wing mixers
0%
–––
0%
–––
0%
–––
177
Advertisement
Table of Contents
