Table of Contents
Advertisement
Telemetry
The menus gathered under the heading »Telemetry«
can be called up from the
mc-32
ter's basic display with a tap of about one second
duration on the centre
ESC
key of the left touch pad.
The same menus can, like other transmitter menus,
also be opened in the multifunction menu with a tap
SET
on the centre
key of the right touch pad:
Wing mixers
Free mixers
MIX active/phase
MIX-only channel
Dual mixer
Fail-safe adjust
Teacher / pupil
Tx. output swap
Profi trim
Trim memor y
Telemetr y
Channel sequence
Free mixers
MIX active/phase
MIX-only channel
Dual mixer
Swashplate mixer
Fail-safe adjust
Teacher / pupil
Tx. output swap
Profi trim
Trim memor y
Telemetr y
Channel sequence
Basic operation
Operating the »Telemetry« menu is essentially the
same as for the remaining
mc-32
ter menus. The few differences are described in the
following:
The selection keys of the left or right touch pad
can be used to switch between individual pages of
the Telemetry menu. Corresponding directional indi-
cators can be found at top right of each display page
in the form of angled brackets ( ), refer to the fi gures
below.
If only one angled bracket is visible, you are on either
the fi rst or last respective page. In this case, changing
pages is only possible in the indicated direction.
HoTT transmit-
Menu lines in which parameters can be changed are
identifi ed with the aforementioned angled bracket ( ).
The " " pointer will jump a line forward or back with a
tap on the selection keys of the left or right touch
pad. Lines to which a jump cannot be made are unal-
terable.
In order to change a parameter, briefl y touch the cen-
SET
tre
key of the right touch pad (the parameter will
be displayed in inverse video), ...
TELEMETRY
RX CURVE
CURVE1 CH : 02
TELEMETRY RCV
SETTING & DATAVIEW
CURVE2 CH : 03
SENSOR SELECT
CURVE3 CH : 04
RF STATUS VIEW
>5CH
VOICE TRIGGER
...change the value within the permissible adjustment
range via the selection keys of the right touch pad
and adopt the value with another tap on the
A brief tap on the centre
pad will cause a return to the starting position again.
Now use the selection keys of the left or right
touch pad to pick the desired sub-menu. However, if
HoTT transmit-
the message ...
V3.98<>
BIND. 1
TYPE :
A
TYPE :
A
TYPE :
B
FUNCTION:SERVO
SET
key.
ESC
key of the left 4-way
CAN NOT
RECEIVE
DATA
OK
... appears instead of the desired sub-menu after
SET
touching the centre
key of the right touch pad
then no connection has been established with a
receiver. Therefore, switch on your receiver system
or, if applicable reconnect the addressed receiver
as described on page 86 or 94 or activate it as
described under "Important Notices" on the previous
page.
Program description - Telemetry
245
Advertisement
Table of Contents
