Finisher Sensor (Stapler Access Door Interlock) Removal; Finisher Sensor (Stapler Pass Thru) Removal - Lexmark X792 Service Manual

Finisher sensor (stapler access door interlock) removal

1.
Remove the finisher from the printer.
2.
Remove the finisher rear cover. See
3.
Disconnect the cable from the sensor.
4.
Pinch tab (A) to remove the sensor.

Finisher sensor (stapler pass thru) removal

See"Finisher assembly" on page 7-32
1.
Remove the finisher from the printer.
2.
Remove the finisher rear cover. See
3.
Remove the finisher front cover. See
4.
Open the left access door, and pry out the left hinge (A) to lower the door.
5.
Push the door to the right to release the left hinge, and then release the right hinge.
"Finisher or stacker rear cover removal" on page
for the part number.
"Finisher or stacker rear cover removal" on page
"Finisher or stacker front cover removal" on page
7562
4-322.
4-322.
4-313.
4-327
Repair information