Lexmark X792 Service Manual page 713

Cable location table
P/N item number
40X7168 10J0937
(Cont.)
10J0939
10J0942
10J0947
10J0948
10J0949
10J0951
10J0953
10J0957
10J0967
40X7170 10J0943
10J0950
10J0960
Description Location
Thermistor & Behind fuser
redrive cable
System board connector:
JFSRD1
HVPS cable Under HVPS board
• System board connector:
JHVPS1
Input option Bottom frame
cable
• System board connector:
JIOPT1
Ground strap Front system board cage
cable support above LVPS
Duplex door Behind LVPS exit duct, through
beacon cable, left rear frame to left access
side door
• System board connector:
JDDLED1
Ref edge Staging paper path reference
ground cable edge
Paper path Paper path redrive
redrive sensor
• System board connector:
cable
JRDR1
Blower & right Behind blower, on top frame
side waste under printhead access cover
cable
• System board connector:
JBLW1
Duplex unit Behind LVPS exit duct, through
cable left rear frame to left access
door
• System board connector:
JDP1
Waste toner • System board connector:
full cable JWTBF1
Waste toner Under lower frame cable cover
cable
• System board connector:
JWTB1
Bin-full sensor Top cover
cable
• System board connector:
JTCVR1
Front door Waste toner left cover
beacon cable
To access
See "Fuser thermistor removal"
on page 4-59.
See "High-voltage power supply
(HVPS) board removal" on
page 4-60.
1. Remove the bottom plate of the
printer. See steps 1 through 5 of
"MPF breakaway assemblies
removal" on page 4-86.
2. Push the cable up through the
frame.
3. Stand the printer back up, and
remove the cable
Note:Use cable ties to attach the
toroid to the new cable.
1. Remove the rear cover. See
"Rear cover removal" on
page 4-21.
2. Remove the strap from the top of
the LVPS.
See "LVPS exit duct removal" on
page 4-77
and
"Left cover removal" on
page 4-15.
See "Staging paper path
reference edge assembly
removal" on page 4-128.
See "Paper path redrive assembly
with sensors removal" on
page 4-106.
See "Printhead access cover
removal" on page 4-20.
See "LVPS exit duct removal" on
page 4-77
and
"Left cover removal" on
page 4-15.
See "Waste toner full cable
removal" on page 4-146.
See "Waste toner cable removal"
on page 4-144.
See AIO cavelight cable in
panel cables removal" on
page 4-101.
See "Waste toner left cover
removal" on page 4-29.
Parts catalog
7562
"OP
7-45